Niels Vertegaal, a doctoral candidate at TU Eindhoven, is developing an inflatable antenna to learn more about the Big Bang. The antenna can capture extremely faint signals in space that are 14 billion years old. The project was tested this week at an altitude of 30 kilometers.
the experimentWednesday, December 6th is the day. TU/e doctoral candidate Niels Vertegaal (29) has been in the English city of Sheffield for a few days, but today the weather conditions are good enough to send his inflatable radio telescope with a weather balloon to an altitude of about 30 kilometers in the stratosphere.
"He has departed," he messages from the testing grounds of the company Sent into Space in England. Now it’s a waiting game to see if the experiment goes well.
20 kilometer altitudeWhen the weather balloon reaches an altitude of 20 kilometers, the antenna begins to unfold. As it ascends beyond 30 kilometers into increasingly sparse air, the balloon will swell due to the growing pressure difference and eventually rupture.
If all goes well, Vertegaal should have gathered enough measurements in the short time beforehand to determine if the antenna is functioning properly. A parachute is meant to safely and without damage bring the equipment back to Earth. Vertegaal has tested the antenna in the Electrical Engineering lab several times, and it went well.
every gram counts"Every gram that goes into space is very precious," explained Vertegaal a week before departure. "So the question is how to make an antenna that is large in space but very small and light when launched."
Hence Vertegaal’s idea to create an inflatable antenna. "In a vacuum, you only need a very small amount of air to inflate something." To test this, he took a prototype of the antenna to England, where a company specializes in conducting and guiding such experiments.
small boxThe antenna is packaged in a small cube measuring 10x10x10 centimeters (1 liter) during the ’launch’. Inside, there is an ultra-thin film that unfolds to a surface area of one square meter. The film has a conductive copper layer of 2 micrometers, which acts as a radio receiver.
The unfolding process involves inflating the arms of the antenna with a minimal amount of compressed air, followed by a small dose of CO2. In a where Vertegaal tests the antenna in the electronic laboratory in the Flux building, it looks like inflating a balloon, gradually revealing the final form.